Back home   |   Bookmark   |   Start page   |   Site map    
Services
News
Channels
Home & Family
Leisure
Technology
Business
Science
Site Search
Free email




New decontamination system kills anthrax rapidly

TheAllINeed.com
(NC&T/GIT) Researchers at the Georgia Tech Research Institute (GTRI) in collaboration with Austin-based Stellar Micro Devices, Inc. (SMD) have developed prototypes of a rapid, non-disruptive and less expensive method that could be used to decontaminate bioterrorism hazards in the future.

Using flat panel modules that produce X-rays and ultraviolet-C (UV-C) light simultaneously, the researchers can kill anthrax spores in two to three hours without any lingering effects. The system also has the ability to kill anthrax spores hidden in places like computer keyboards without causing damage.

"This is certainly an improvement over previous techniques," said Brent Wagner, GTRI principal research scientist and director of its Phosphor Technology Center of Excellence (PTCOE). "The UV-C attacks spores on surfaces and the X-rays penetrate through materials and kill spores in cracks and crevices."

X-ray irradiation is used commercially to sterilize medical products and food by disrupting the ability of a microorganism to reproduce. UV-C also prevents replication, but both types of radiation can penetrate the outer structure of an anthrax spore to destroy the bacteria inside.

The current decontamination standard – chlorine dioxide gas – kills microorganisms by disrupting transport of nutrients across the cell wall, but cannot reach hidden spores. Hard surfaces must be cleaned independently with harsh liquid chlorine dioxide. In addition, people cannot re-enter a room fumigated with chlorine dioxide until the gas is neutralized with sodium bisulfite vapor and vented from the building.

GTRI research scientists Brent Wagner and Hisham Menkara optimized a UV-C phosphor for use in a flat panel system with X-rays that can kill anthrax spores in two to three hours without any lingering effects. (Photo: Georgia Tech/Gary Meek)
The new decontamination system resembles a coat rack with radiation modules arranged on rings at various heights that face outward to broadcast radiation throughout a room. Since the X-rays and UV-C are lethal at the flux densities used, the system operates unattended and is turned on outside the affected space.

UV-C light in the modules is produced using the optical and electrical phenomenon of cathodoluminescence. Numerous electron beams are generated by arrays of cold cathodes, each acting like the electron gun in a cathode ray tube.

"When an electron beam hits a powder phosphor, it luminesces and emits visible and/or non-visible light," explained Hisham Menkara, a GTRI senior research scientist.

GTRI became involved in SMD's project, which was funded by the Air Force Research Laboratory's Small Business Innovation Research program, because the PTCOE housed UV-C phosphors created and patented by Sarnoff Corporation in the mid-1970s.

"We knew that Georgia Tech had experts in powder phosphors with regard to flat panel displays and we approached them to develop new phosphors for our decontamination purpose," said Mark Eaton, president and CEO of SMD. "We were fortunate that they had UV-C phosphors available from decades earlier."

With the Sarnoff phosphors in hand, Wagner and Menkara set off to determine the best UV-C emitting phosphor and optimize its properties for use with X-rays in SMD's small flat panel display.

To find the best phosphor that emitted light in the UV-C region of the spectrum – wavelengths below 280 nanometers – the emission spectra of each phosphor was measured against the DNA absorption curve. This curve shows the optimal wavelengths to destroy an organism's DNA.

After investigating many different phosphors, the researchers chose lanthanum phosphate:praseodymium (LaPO4:Pr or LAP:Pr) as the most efficient phosphor, with a power efficiency near 10 percent. Since the UV emission didn't fall completely under the DNA absorption curve, the relative "killing efficiency" was approximately 50 percent.

In the laboratory, Menkara created the phosphor by mixing precursors lanthanum oxide, hydrogen phosphate and praseodymium fluoride (La2O3, H3PO4 and PrF3, respectively) in a glass beaker with methanol (CH3OH) and ammonium chloride (NH4Cl). Air drying the mixture in a fume hood caused the methanol to completely evaporate.

The resultant cake was crushed into a fine powder, heated in a furnace to a temperature as high as 1250 degrees Celsius for two hours and crushed again.

"To determine the best conditions for producing the highest efficiency phosphor, we tried different precursors and completed the firing under different atmospheric conditions and temperatures," explained Menkara.

Test results showed that higher temperatures were more efficient and a capped quartz tube was the best container to hold the powder inside the furnace. Wagner and Menkara also found that adding lithium fluoride (LiF) and reducing the praseodymium concentration increased the cathodoluminescent properties of the LAP:Pr phosphor.

With the improved phosphor, laboratory tests conducted by SMD showed that the combined X-ray and UV-C decontamination system could kill anthrax spores.

GTRI researchers hope to develop new UV-C phosphors that can achieve cathodoluminescent efficiency higher than 10 percent with an emission spectrum that provides increased coverage of the DNA absorption curve.

With increased efficiency, UV-C panels could be used for sterilizing medical equipment or purification applications.

"We may be able to use UV-C panels to clean wastewater, which would be better than the lamps currently used. In the environment where the lamps must operate, they are very difficult to clean, whereas flat panels could be cleaned with a squeegee," noted Eaton.

Another potential application is to kill viruses in buildings used to house chickens. Current methods involve removing the chickens and raising the temperature in the chicken houses for several days to deactivate the virus.

"With the combined UV-C/X-ray system, you could turn the system on for a few hours, kill the viruses and as soon as you turn it off, the chickens could come right back in," said Wagner.


About the Author
©2006 All rights reserved

More articles
Human auditory neurons
Improve vehicle safety
Motorcycle helmets
Evaluating item
Detecting alzheimer's
Scar-free healing
1000 genomes project
Asthma attacks
Middle-aged misery
Blue-eyed humans
New mit tool probes brain circuits
Anthrax
Destined to lie, cheat or steal?
Accelerated head growth autism
Process fear memories
Fingertip dexterity
Momentary sadness increases spending
DNA
Irregular exercise pattern
Effectiveness of microneedles
Quotes
Friendship is born at that moment when one person says to another, What! You too? I thought I was the only one! -- C.S. Lewis

For the man who has everything. -- A sign in a Manchester shop above a display for burglar alarms

For the scientific acquisition of knowledge is almost as tedious as the routine acquisition of wealth. — Eric Linklater (1899-1974)


Writers
If you are a writer and want to see your article published at Theallineed.com, just click here to submit.

Info
Today...
In the news...
Poverty reflected in children's schools as well as in the home
The report, which is based on a survey of 7,600 schools in 11 countries in Latin America, Asia and North Africa, reveals a particularly glaring gap between the resources available to urban and rural schools.
What are some of the products that you are shopping online?
Clothing and Footwear
Vehicle Purchasing
House Buying
Electronics
Computers
Music
Books
Other
 
Things to ponder
Would a fly without wings be called a walk?

Did you know...
Human nails and hair do not grow after death. After you die, your body starts to dry out creating the illusion that your hair and nails are still growing after death.

Quote of the day
Even he, to whom most things that most people would think were pretty smart were pretty dumb, thought it was pretty smart.
Douglas Adams

Featured article
Help Hair Grow
Hair gives natural beauty to all person which can improve the appearance, feeling, personality and expression. Shiny hair is a sign of health because the layers of the cuticle lie flat and reflect light.

 
© 2002 - 2007 Lexur