Rain sensors? In most states it's the law!

Craig Borglum

Does your sprinkler system know if it's raining? It can by adding a simple devise known as a "rain sensor."

For this reason every lawn sprinkler system should have a rain sensor. The rain sensor determines whether or not enough rainfall has occurred in order to skip an irrigation cycle.

There are three basic types of rain sensors. They all serve the same purpose: keeping your system from over-watering the turf or your garden. How does it do that?

The electrical connection between the sensor and your sprinkler system controller is interrupted when a certain amount of rain triggers the device. The sensor breaks the electrical connection so that electricity cannot flow to either the sprinkler valves or to a pump start (if your system is on a well without a pressure tank).

One type breaks the connection by weighing the water in a rainfall collection cup. The problem with this type is that leaves, sticks, or the occasional lizard will find its way into the collection cup and therefore turning off the system.

The next type uses electrodes to determine how much water is in the collection cup. This kind of rain sensor device also has a system problem of collecting things other than rainfall in the collection cup.

The expansion disk type seems to be the most popular. This kind of sensor does not use a collection cup; instead rainfall causes cork disks to expand. This device uses a pressure switch to break the electrical connection. These can be adjusted in increments of ¼" to the desired rain fall setting. These adjustments can be configured to kick in from 1 to a 1/2" of rain has fallen.

The most important aspect of installing a rain sensor is where to place it. It should be installed in an area that is unobstructed by trees, roof over hangs, or anything else that might block rain from getting to the sensor.

Wired rain sensors are usually installed by the timer. The wires should be connected inside the controller's valve wiring panel. This allows for easier electrical trouble-shooting of the system as the sensor can be easily disconnected.

Year by year, as technology improves, FM sensors have become more popular. Although they are more expensive than the wired devices, the ease of installation and increased placement options offset the cost. Most wireless units come with by-pass switches built into the device.

Some digital controllers also offer by-pass options for both wired devices and wireless rain sensors. No matter the type of rain sensor type that you choose, all rain sensors offer many advantages over not adding this detector to your automatic sprinkler system.

Some of the immediate and long term benefits include:

- Saves Money. Whether you pay for city water or spend electricity running a pump, the money you save over time will more than pay for the rain sensor.

- Extends Sprinkler System Life Span. Sprinklers are made up of gears and other parts that move. The less the sprinkler parts are used, the longer they last.

- Protects Water Resources. By limiting the over use of your sprinkler system, rain sensors reduce excess water run-off that carries fertilizers and pest control chemicals into our shared water supply.

- Conserves Water. Less water is wasted when less supplemental water is needed for your turf and in your garden.

How much money can you save with a rain sensor device? It will vary based on your water source (city, re-claim, or well) and where you live (water costs, electrical rate, climate).

Here is one example that demonstrates the benefits listed above: Seminole County, Florida. System Description:

Intended to sprinkle a 1/4 acre of turf calibrated to precipitate a half inch" of water every time the system runs.

- This schedule would equal 6,788 gallons per irrigation cycle.

- This system (on City Water) pays $2.30 per thousand gallons.

- Every time the rains sensor interrupts a sprinkler cycle, you would save $15.61

According to a recent study in Florida, the use of a rain sensor device averaged a 45% savings in water for single-family residential water usage. The next time you see a sprinkler system running in the rain, you now know it doesn't have to be that way. Rain sensors are affordable solutions to conserving our water, protecting our water resources, and saving you money.






This site is no longer updated.

Click this link to have updated home improvement news and articles.

About the Author
Craig Borglum is an EPA Water Sense Partner and a nationally Certified Irrigation Designer. DIY irrigation DVD's are available at http://www.IrrigationRepair.com
©TheAllINeed.com All rights reserved




More articles